Hello. I hope this is the right place to ask. If not, i apologize. I have a strange problem with the bogey i am making. When i started making it it was very large, because i was making it by a blueprint. After scaling it to normal i found a problem. As you can see on the picture, i had to use "Normal" tool to fix these objects. Then came the other problem - the lighting, when i used the tool it turns out that the lighting is mirrored (flipped if you like). Where the light falls on the bogey is actully mirrored on the other side if you understand me. See for your self on the last picture. If anyone had the same problem, please help me out.
Before I applied the tool.
Applying the tool.
After the "Normal tool".
The result.
